Port Display-Blackdiamond 10K Series Switch Only - Extreme Networks ExtremeWare XOS Guide Manual

Port Display—BlackDiamond 10K Series Switch Only
The switch displays slightly different information for various ports, depending on the speed and media.
The following command displays more specific information for a slot 1, port 1 on a BlackDiamond 10K
switch:
show ports 1:1 information detail
Following is sample output from this command:
Port: 1:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
Name: peggy, Internal Tag = 4094, MAC-limit = No-limit
STP cfg:
Protocol:
Name: peggy
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Unicast Flooding:
Multicast Flooding:
Broadcast Flooding:
Jumbo:
BG QoS monitor: Unsupported
QoS Profile:
Queue:
QP1
QP2
QP3
QP4
QP5
QP6
QP7
QP8
Ingress Rate Shaping :
Ingress IPTOS Examination:
Egress IPTOS Replacement:
Egress 802.1p Replacement:
NetLogIn:
Smart redundancy:
Software redundant port:
Primary:
Redundant:
Redundant link configuration: Off
autopolarity:
ExtremeWare XOS 11.3 Concepts Guide
UTP
Disabled
Enabled with auto-speed sensing
Active, 100Mbps, full-duplex
1 time(s)
Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Enabled
Enabled
Disabled
None configured
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
MinBw = 0% MaxBw =
Unsupported
Disabled
Disabled
Disabled
Disabled
Enabled
Enabled
1:1
1:2
Enabled
Displaying Port Configuration Information
auto-duplex
Match all protocols.
100% Pri = 1
100% Pri = 2
100% Pri = 3
100% Pri = 4
100% Pri = 5
100% Pri = 6
100% Pri = 7
100% Pri = 8
145