The following is an example of the output you see when you display the LACP information for port 5
on the Summit X450 switch:
Member
Rx
Port
State
--------------------------------------------------------------------------------
5
Current
================================================================================
Actor Flags: A-Activity, T-Timeout, G-Aggregation, S-Synchronization
C-Collecting, D-Distributing, F-Defaulted, E-Expired
The following is an example of the output you see when you add the
the Summit X450 switch:
Member
Rx
Port
State
--------------------------------------------------------------------------------
5
Current
Up
: Yes
Enabled
: Yes
Link State
: Up
Ready_N
: Yes
Wait pending : No
Ack pending
: No
LAG Id:
S.pri:0
, S.id:00:04:96:1f:a5:2e, K:0x03ed, P.pri:0
T.pri:0
, T.id:00:04:96:1f:a5:76, L:0x03ed, Q.pri:0
Stats:
Rx - Accepted
Rx - Dropped due to error in verifying PDU
Rx - Dropped due to LACP not being up on this port : 0
Rx - Dropped due to matching own MAC
Tx - Sent successfully
Tx - Transmit error
================================================================================
Actor Flags: A-Activity, T-Timeout, G-Aggregation, S-Synchronization
C-Collecting, D-Distributing, F-Defaulted, E-Expired
Refer to
"Displaying Port Configuration Information"
sharing information.
To clear the counters, issue the following command:
clear lacp counters
Switch Port Mirroring
NOTE
Beginning with ExtremeWare XOS software version 11.2, you can accomplish port mirroring using ACLs or
CLEARFlow. See
Chapter 13
ExtremeWare XOS 11.3 Concepts Guide
Sel
Mux
Logic
State
Selected
Collect-Dist
Sel
Mux
Logic
State
Selected
Collect-Dist
for more information on ACLs and
Actor
Partner
Flags
Port
A-GSCD--
1005
parameter for port 5 on
detail
Actor
Partner
Flags
Port
A-GSCD--
1005
, P.num:1005
, Q.num:1005
: 13980
: 0
: 0
: 13979
: 0
for information on displaying summary load-
Chapter 18
for more information on CLEAR-Flow.
Switch Port Mirroring
129