Mac-Based Network Login Configuration Example; Additional Network Login Configuration Details - Extreme Networks ExtremeWare XOS Guide Manual

To view your network login configuration, use one of the following commands:
●
show netlogin {port <portlist> vlan <vlan_name>} {dot1x {detail}} {mac} {web-
based}
●
show netlogin mac-list

MAC-Based Network Login Configuration Example

The following configuration example shows the Extreme Networks switch configuration needed to
support the MAC-based network login example.
create vlan "temp"
create vlan "corp"
configure vlan "default" delete ports 4:1-4:4
# Configuration Information for VLAN corp
# No VLAN-ID is associated with VLAN corp.
configure vlan "corp" ipaddress 10.203.0.224 255.255.255.0
# Network Login Configuration
configure netlogin vlan "temp"
enable netlogin mac
enable netlogin ports 4:1-4:4 mac
configure netlogin add mac-list default <password>
# RADIUS Configuration
configure radius netlogin primary server 10.0.1.2 1812 client-ip 10.10.20.30 vr "VR-
Mgmt"
configure radius netlogin primary shared-secret purple
enable radius
The following example is for the FreeRADIUS server; the configuration might be different for your
RADIUS server:
#RADIUS Server Setting
00E018A8C540 Auth-Type := Local,
NOTE
For information about how to use and configure your RADIUS server, please refer to the documentation that came
with your RADIUS server

Additional Network Login Configuration Details

This section describes how to configure netlogin MAC-based VLANs on the BlackDiamond 8800 family
of switches and the Summit X450 switch. Please review the earlier sections of this chapter for general
information about network login and information about MAC-based, web-based, and 802.1x
authentication methods.
ExtremeWare XOS 11.3 Concepts Guide
Additional Network Login Configuration Details
User-Password == "00E018A8C540"
371