Extreme Networks ExtremeWare XOS Guide Manual page 520

IPv6 Unicast Routing
NOTE
If you define a default route and subsequently delete the VLAN on the subnet associated with the default route, the
invalid default route entry remains. You must manually delete the configured default route.
Dynamic Routes
Dynamic routes are typically learned by way of RIPng or OSPFv3. Routers that use RIPng or OSPFv3
exchange information in their routing tables in the form of advertisements. Using dynamic routes, the
routing table contains only networks that are reachable.
Dynamic routes are aged out of the table when an update for the network is not received for a period of
time, as determined by the routing protocol.
Static Routes
Static routes are manually entered into the routing table. Static routes are used to reach networks not
advertised by routers.
Static routes can also be used for security reasons, to control which routes you want advertised by the
router. You configure, if you want all static routes to be advertised, using one of the following
commands:
●
enable ripng export [direct | ospfv3 | ospfv3-extern1 | ospfv3-extern2 | ospfv3-
inter | ospfv3-intra | static] [cost <number> {tag <number>} | policy <policy-
or
name>]
ospfv3-inter | ospfv3-intra | static]
●
enable ospfv3 {domain <domainName>} export [direct | ripng | static] [cost <cost>
type [ase-type-1 | ase-type-2] {tag <number>} | <policy-map>]
{domain <domainName>} export [direct | ripng | static]
The default setting is disabled. Static routes are never aged out of the routing table.
A static route's nexthop (gateway) must be associated with a valid IP subnet. An IP subnet is associated
with a single VLAN by its IP address and subnet mask. If the VLAN is subsequently deleted, the static
route entries using that subnet must be deleted manually.
Multiple Routes
When there are multiple, conflicting choices of a route to a particular destination, the router picks the
route with the longest matching network mask. If these are still equal, the router picks the route using
the following default criteria (in the order specified):
Directly attached network interfaces
●
Static routes
●
ICMP redirects
●
Dynamic routes
●
Directly attached network interfaces that are not active.
●
520
disable ripng export [direct | ospfv3 | ospfv3-extern1 | ospfv3-extern2 |
or
disable ospfv3
ExtremeWare XOS 11.3 Concepts Guide