Rstp 802.1W Configuration Example - Extreme Networks ExtremeWare XOS Guide Manual

Spanning Tree Protocol
configure green add ports 1:1-1:2 tagged
create vlan yellow
configure yellow tag 300
configure yellow add ports 1:3-1:4 tagged
create stpd s1
configure stpd s1 add green ports all
configure stpd s1 tag 200
configure stpd s1 add red ports 1:1-1:2 emistp
enable stpd s1
create stpd s2
configure stpd s2 add yellow ports all
configure stpd s2 tag 300
configure stpd s2 add red ports 1:3-1:4 emistp
enable stpd s2

RSTP 802.1w Configuration Example

Figure 48 is an example of a network with multiple STPDs that can benefit from RSTP. For RSTP to
work, you need to do the following:
Create an STPD.
●
Configure the mode of operation for the STPD.
●
Create the VLANs and assign the VLANid and the VLAN ports.
●
Assign the carrier VLAN.
●
Add the protected VLANs to the STPD.
●
Configure the port link types.
●
Enable STP.
●
450
ExtremeWare XOS 11.3 Concepts Guide