Leds - Extreme Networks ExtremeWare XOS Guide Manual

Troubleshooting
Use the following commands to display OSPFv3 information:
■
show ospfv3
■
show ospfv3 area
■
show ospfv3 interfaces
Your Routing Information Protocol (RIP) configuration, including RIP poison reverse, split horizon,
●
triggered updates, transmit version, and receive version.
NOTE
RIP is applicable only in IPv4 environments.
Use the
show rip
the switch.
RIP activity and statistics for all VLANs on the switch.
●
NOTE
RIP is applicable only in IPv4 environments.
Use the
show rip interface
Your RIP next generation (RIPng) configuration, including RIPng poison reverse, split horizon,
●
triggered updates, transmit version, and receive version.
NOTE
RIPng is applicable only in IPv6 environments.
Use the
show ripng
configured on the switch.
RIPng activity and statistics for all VLANs on the switch.
●
NOTE
RIPng is applicable only in IPv6 environments.
Use the
show ripng interface
End-to-end connectivity.
●
Use the
ping
The routed path between the switch and a destination end station.
●
Use the
traceroute

LEDs

Power LED does not light:
Check that the power cable is firmly connected to the device and to the supply outlet.
612
—Displays global OSPFv3 information for the switch
—Displays information related to OSPFv3 areas
—Displays detailed information about OSPFv3 interfaces
command to display detailed information about how you have RIP configured on
detail
command to display detailed information about how you have RIPng
command to display RIPng-specific statistics for all VLANs.
command to test for connectivity to a specific host.
command to verify and trace the routed path.
command to display RIP-specific statistics for all VLANs.
ExtremeWare XOS 11.3 Concepts Guide