Verifying Qos Configuration And Performance; Monitoring Performance-Blackdiamond 10K Switch Only - Extreme Networks ExtremeWare XOS Guide Manual

Link Counter: Up
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: Unsupported
QoS Profile:
Queue: Qp1
Qp2
Qp3
Qp4
Qp5
Qp6
Qp7
Qp8
Ingress Rate Shaping :
IQP1
IQP2
Ingress IPTOS:
Egress IPTOS:
Egress 802.1p:
Smart Redundancy:
VLANs monitored for stats:
Software redundant port:
jitter-tolerance:
NOTE
To ensure that you display the QoS information, you must use the detail variable.

Verifying QoS Configuration and Performance

You can display a variety of QoS measures using the CLI.
Monitoring Performance—BlackDiamond 10K Switch Only
NOTE
This command is not supported on the BlackDiamond 8800 family of switches or on the Summit X450 switch.
ExtremeWare XOS 11.3 Concepts Guide
0 time(s)
Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Disabled
None configured
MinBw=0% MaxBw=100% Pri=1
MinBw=0% MaxBw=100% Pri=2
MinBw=0% MaxBw=100% Pri=3
MinBw=0% MaxBw=100% Pri=4
MinBw=0% MaxBw=100% Pri=5
MinBw=0% MaxBw=100% Pri=6
MinBw=0% MaxBw=100% Pri=7
MinBw=0% MaxBw=100% Pri=8
support IQP1-2
MinBw= 0% MaxBw=100% Pri=1
MinBw= 0% MaxBw=100% Pri=2
Disabled
Replacement disabled
Replacement disabled
Unsupported
Unsupported
Unsupported
Unsupported
Verifying QoS Configuration and Performance
Match all protocols.
Unsupported
307