To display the IGMP snooping filters, use the following command:
show igmp snooping {vlan} <name> filter
Configuring IP Multicast Routing
To configure IP multicast routing:
1 Configure the system for IP unicast routing.
2 Enable multicast routing on the interface using the following command:
enable ipmcforwarding {vlan <name>}
3 Enable PIM on all IP multicast routing interfaces using the following command:
configure pim add vlan [<vlan_name> | all] {dense | sparse} {passive}
4 Enable PIM on the router using the following command:
enable pim
Configuration Examples
Figure 78
and
Figure 79
are used in
configuration on a switch. See
ExtremeWare XOS 11.3 Concepts Guide
Chapter 25
to describe the Open Shortest Path First (OSPF)
Chapter 25
for more information about configuring OSPF.
Configuring IP Multicast Routing
583