Extreme Networks ExtremeWare XOS Guide Manual page 127

Dynamic link aggregation—LACP
●
To verify your configuration, use the following command:
show ports sharing
The following is an example of the display you see when you display load sharing, or link aggregation,
on the Summit X450 switch:
Load Sharing Monitor
Config Current
Master Master
==============================================================================
5 5
12
===========================================================================
Link Status: A-Active, D-Disabled, R-Ready, NP-Port not present
Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based
Default algorithm: L2
Number of load sharing trunks: 2
NOTE
The Agg Mbr column displays which ports in the LACP LAG are added to the aggregator at the hardware level. Only
those ports that are added to the aggregator actually send and receive traffic. The Y means the port is added to the
aggregator.
To verify LACP configuration, issue the following command:
show lacp
The following is an example of the output you see when you display the LACP information on the
modular switch:
LACP Up
LACP Enabled
System MAC
LACP PDUs dropped on non-LACP ports : 0
Lag Actor Actor
Sys-Pri Key
--------------------------------------------------------------------------------
2:1 90 0x07d1
4:5 100 0x0fa5
4:9 677 0x0fa9
To display information for the specified LAG, issue the following command:
show lacp lag <group-id> {detail}
The following is an example of the output you see when you display the LACP information for this
command on a modular switch:
ExtremeWare XOS 11.3 Concepts Guide
Agg Ld Share
Control Algorithm
LACP L2
L2
L2
L2
L2
L2
Static L2
L2
: Yes
: Yes
: 00:04:96:10:33:60
Partner
MAC
00:01:30:f9:9c:30
00:01:30:f9:9c:30
00:01:30:f9:9c:30
Link Aggregation on the Switch
Ld Share Agg Link
Group Mbr Status
5 Y A
6 Y A
7 Y A
8 Y A
9 - A
10 - A
12 - R
13 - R
Partner Partner
Sys-Pri Key
601 0x1391
321 0x1f47
87 0x0fa9
Link Up
transitions
3
3
3
3
3
3
0
0
Agg
Count
2
16
8
127