Software Factory Defaults - Extreme Networks ExtremeWare XOS Guide Manual

ExtremeWare XOS Overview
Email address
●
Ability to use a Web browser to download a file
●
WinZip format to uncompress a .zip file
●
Security Features Under License Control
ExtremeWare XOS software supports the SSH2 protocol, which allows the encryption of sessions
between an SSH2 client and an Extreme Networks switch, as well as the Secure Copy Protocol (SCP).
The encryption methods used are under export restriction control.

Software Factory Defaults

Table 4 shows factory defaults for global ExtremeWare XOS software version 11.3 features.
Table 4: ExtremeWare XOS version 11.3 global factory defaults
Item
Serial or Telnet user account
Telnet
Port status
SSH2
SNMP access
SSL
SNMP read community string
SNMP write community string
BOOTP/BOOTP Relay/BOOTP Client
Jumbo frames
EAPS
EDP
Port mirroring
Load sharing
ESRP
QoS
QoS—802.1p replacement
QoS—DiffServ examination
VMAN—examining inner dot1p value
Autonegotiation
Virtual LANs
36
Default Setting
admin with no password and user with no password
Enabled
Enabled
Disabled (You must install a separate software module to run SSH.)
Enabled
Disabled (You must install a separate software module to run SSL—
SSH module.)
public
private
Disabled
Disabled; once enabled, the default size is 9216.
Disabled
Enabled
Disabled
Disabled
Disabled
All traffic is part of the default queue (QP1).
Disabled
Disabled
Disabled
• 10 G modules—autonegotiation OFF, speed 10000 Mbps, full-
duplex
• 1 G modules—autonegotiation ON
Two VLANs are predefined; the VLAN named default contains all
ports and belongs to the Spanning Tree Protocol Domain (STPD)
named s0. The VLAN mgmt exists only on switches that have an
Ethernet management port and contains only that port. The switch
uses the Ethernet management port for host operation only, not for
switching or routing.
ExtremeWare XOS 11.3 Concepts Guide