Unconfiguring Lldp; Displaying Lldp Settings; Displaying Lldp Port Configuration Information - Extreme Networks ExtremeWare XOS Guide Manual

Link Layer Discovery Protocol
You advertise the maximum frame size available on the LLDP-enabled port using the maximum frame
size TLV. To advertise the maximum frame size, issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot3 max-frame-size

Unconfiguring LLDP

To unconfigure LLD, issue the following command:
unconfigure lldp
This command only returns the LLDP timers to default values; LLDP remains enabled, and all the
configured TLVs are still advertised.
To leave LLDP enabled, but reset the advertised TLVs to the five default TLVs, issue the following
command, and specify the affected ports:
unconfigure lldp port [all | <port_list>]

Displaying LLDP Settings

The system displays information on the LLDP status and statistical counters of the ports, as well as
about the LLDP advertisements received and stored by the system. You can display information on the
LLDP port configuration and on the LLDP neighbors detected on the port.
NOTE
Refer to ExtremeWare XOS Command Reference Guide for complete information on displaying LLDP settings.

Displaying LLDP Port Configuration Information

Use the
show lldp
LLDP information, add the
The following is sample output of the
# show lldp
LLDP transmit interval
LLDP transmit hold multiplier
LLDP transmit delay
LLDP SNMP notification interval : 5 seconds
LLDP reinitialize delay
160
command to display LLDP port configuration information. To display detailed
option.
detailed
show lldp
: 30 seconds
: 4
: 2 seconds
: 2 seconds
command:
(used TTL = 120 seconds)
ExtremeWare XOS 11.3 Concepts Guide