Extreme Networks ExtremeWare XOS Guide Manual page 178

Power Over Ethernet
Displaying Port PoE Status
To display the PoE status per port, use the following command:
show inline-power info {detail} ports <port_list>
This command provides the following information:
State—Displays the port power state:
●
Disabled
■
Searching
■
Delivering
■
Faulted
■
Disconnected
■
Other
■
Denied
■
PD's power class—Displays the class type of the connected PD:
●
"-----": disabled or searching
■
"class0": class 0 device
■
"class1": class 1 device
■
"class2": class 2 device
■
"class3": class 3 device
■
"class4": class 4 device
■
Volts—Displays the measured voltage. A value from 0 to 2 is valid for ports that are in a searching
●
or discovered state.
Curr—Displays the measured current, in milliamperes, drawn by the PD.
●
Power—Displays the measured power, in watts, supplied to the PD.
●
Fault—Displays the fault value:
●
None
■
UV/OV fault
■
UV/OV spike
■
Over current
■
Overload
■
Undefined
■
Underload
■
HW fault
■
Discovery resistance fail
■
Operator limit violation
■
Disconnect
■
Discovery resistance, A2D failure
■
Classify, A2D failure
■
Sample, A2D failure
■
Device fault, A2D failure
■
Force on error
■
178
ExtremeWare XOS 11.3 Concepts Guide