Extreme Networks ExtremeWare XOS Guide Manual page 161

LLDP Port Configuration:
Port Rx Tx
Mode Mode
============================================================================
1:1 Enabled Enabled
2:2 Enabled Enabled
=============================================================================
LLDP Flags : (P) Port Description, (N) System Name, (D) System Description
(C) System Capabilities, (M) Mgmt Address
802.1 Flags: (P) Port VLAN ID, (p) Port & Protocol VLAN ID, (N) VLAN Name
802.3 Flags: (M) MAC/PHY Configuration/Status, (P) Power via MDI
(L) Link Aggregation, (F) Frame Size
The following sample output is from the
# show lldp port 1 detailed
LLDP transmit interval
LLDP transmit hold multiplier
LLDP transmit delay
LLDP SNMP notification interval : 5 seconds
LLDP reinitialize delay
LLDP Port Configuration:
Port Rx Tx
Mode Mode
============================================================================
1 Enabled Enabled
VLAN: Default
VLAN: voice
=============================================================================
LLDP Flags : (P) Port Description, (N) System Name, (D) System Description
(C) System Capabilities, (M) Mgmt Address
802.1 Flags: (P) Port VLAN ID, (p) Port & Protocol VLAN ID, (N) VLAN Name
802.3 Flags: (M) MAC/PHY Configuration/Status, (P) Power via MDI
(L) Link Aggregation, (F) Frame Size
Use the
show lldp statistics
The following is sample output from the
# show lldp statistics
Last table change time
Number of Table Inserts
Number of Table Deletes
Number of Table Drops
Number of Table Age Outs : 0
Port Tx Tx Length
Total Exceeded
===================================================================================
1:1 189
2:2 188
ExtremeWare XOS 11.3 Concepts Guide
SNMP
Notification
Disabled
Disabled
show lldp port 1 detailed
: 30 seconds
: 4 (used TTL = 120 seconds)
: 2 seconds
: 2 seconds
SNMP
Notification
Disabled
command to display the statistical counters related to the LLDP port.
show lldp statistics
: Fri Dec 17 10:42:33 2004
: 3
: 0
: 0
Rx Rx
Total Discarded
0 5654
0 565
Optional enabled transmit TLVs
LLDP 802.1 802.3
PNDCM PpN- M-LF
--D-- ---- ----
command:
Optional enabled transmit TLVs
LLDP 802.1 802.3
-ND-- --N- ----
----- ---- ----
----- --N- ----
command:
Rx TLVs
Errors Discarded
0 0
0 0
Displaying LLDP Settings
TLVs
Unrecogn.
0 0
0 0
161