Removing The Fixing Heater - Canon NP6260 Service Manual

CHAPTER 6 FIXING SYSTEM

6. Removing the Fixing Heater

1) Slide out the fixing/feeding unit from
the copier.
2) Remove the fixing/feeding front
cover.
3) Open the fixing delivery assembly.
4) Remove the fixing upper cover, and
remove the fixing cleaning belt;
then, clean the silicone oil pan, and
remove the fixing upper unit.
5) Remove the flywheel.
6) Remove the faston
the heater (main heater, sub
heater).
7) Remove the mounting screw
remove the side electrode supply
leaf spring at the front.
8) Free the two cables
the heater from the wire saddles
9) Remove the two fastons
rear.
10) Pull out the main heater and the sub
heater from the fixing assembly to
the front with care not to damage
them.
Caution:
When opening the fixing upper unit
during inspection/maintenance
work, you could cause the side
plate of the upper fixing unit to
push down the height adjusting
support plate
assembly inlet guide, lowering the
fixing assembly inlet guide. Since
such a condition will lead to
jamming of copy paper, make sure
not to open the fixing assembly
upper unit with force.
6-24
COPYRIGHT © 1997 CANON INC.
at the front of
, and
at the front of
.
at the
of the fixing
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 6-213
Figure 6-214