Adjusting The Left/Right Registration (Paper Deck-A1) - Canon NP6260 Service Manual

b. Cassette
Turn the horizontal registration adjusting screw of each cassette, and make
adjustments so that the copy image and the edge of copy sheet is 0 ±1.5 mm when the
Test Sheet is copied in Direct.
1) Slide out the cassette, and loosen the two screws
inside unit. (The cassette 4 is not equipped with a locking pick.)
2) Detach the paper size plate of the cassette, and turn the horizontal adjusting screw
with a screwdriver

3-1 Adjusting the Left/Right Registration (paper deck-A1)

1) Make a copy of the Test Sheet, and check to make sure that the left/right registration
between copy image and paper deck is 0 ±1.5 mm or less.
2) If the left/right registration is not as specified, adjust the position of the latch plate of
the deck opening solenoid by turning the two adjusting screws. (At this time, use the
scale on the latch plate as a reference.)
COPYRIGHT © 1997 CANON INC.
.
2
1
Figure 11-205
Latch plate
Figure 11-205a (rear left of compartment)
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
and the locking pick
1
3
Scale
Screws
of the
11-7