Canon NP6260 Service Manual page 445

Step
3 Install the feeding assembly front
cover with two screws. While
pushing the rear (fixing/feeding
assembly inside) of the releasing
lever locking shaft; then, lock the
lever in place (lever to the left).
Slide the fixing/feeding assembly
into the machine; then, lock it in
place with the lever.
4 Remove the tag tape; then open the
multifeeder door and the upper right
door, and remove the screw from the
door tape (door stopper) of the front
door (so that the front door will not
close the hopper when the hopper is
opened.)
5 Open the hopper cover, and remove
the three screws and the connector
cover.
6 Disconnect the connector, and
release the hopper assembly.
7 Slide out the hopper assembly to the
front, and turn it 90° to the front right.
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 INSTALLATION
Remarks
Hopper
assembly Screw
Hopper
cover
Screws
Connector
cover
9-11