CHAPTER 11 TROUBLESHOOTING
4. Position of the Roller Electrode
5. Adjusting the Position of the
Cleaning Assembly Side Seal
1) Attach the side seal
location indicated (both ends; make
sure that the edge of the seal is as
follows):
•
If you are replacing the side seal
at the front, push the magnetic roller
toward the rear; then, work so
that the inner edge of the side seal
is within the washer area
•
If you are replacing the side seal
at the rear, push the magnetic roller
toward the front; then, work so
that the inner edge of the side seal
is within the washer area
2) Make sure that the bottom edge of
each side seal
away from the corner of the cleaner
housing.
3) Fix the size seal
rear) to the cleaner housing at the
location indicated.
11-20
COPYRIGHT © 1997 CANON INC.
Roller electrode
Scraper
Figure 11-222
to the
.
.
is 0 to 0.5 mm
(both front and
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
: 0~0.5mm
Figure 11-223