J. Charging Wire
1. Outline
The photosensitive drum is sur-
rounded by three charging wires: prima-
ry, pre-transfer, transfer/separation,
each of which is 0.06 mm in diameter.
2. Removing the Wire Cleaner of the
Primary Charging Assembly
1) Pick the wire cleaner with fingers,
and disengage the hook with a
screwdriver.
3. Stringing the Charging Wires
As a rule, with the exception of the
grid wire, all charging wires are strung in
the same way; here, the charging
assembly is used to show the steps.
1) Remove the shielding plate (left,
right) of the charging assembly. To
prevent deformation (slack) of the
charging assembly, be sure to
remove the left and the right shield-
ing plates individually (i.e., do not
loosen the mounting screws
both plates at the same time).
2) Remove the wire cleaner.
COPYRIGHT © 1997 CANON INC.
of
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
Figure 4-323
Figure 4-324
4-51