Stringing The Grid Wire Of The Primary Charging Assembly - Canon NP6260 Service Manual

Caution:
After stringing the wire, check to
make sure that
• It is not bent or twisted in the
middle.
• It is in the V-groove of the charg-
ing wire positioner.
9) Install the cushion at the front of the
charging wire. (This does not apply
to the primary charging assembly.)
10) Install the shielding plates (left,
right).
Caution:
For other charging assemblies,
install the two lids.
11) Install the wire cleaner. (At this time,
be sure that the cleaner is oriented
correctly.)
12) Clean the charging wire with lint-free
paper moistened with alcohol.
4. Stringing the Grid Wire of the
Primary Charging Assembly
1) Loosen the two mounting screws
used to keep the left and the right
shielding plates in place.
2) Loosen the three mounting screws
used to keep the motor unit at the
front in place.
COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
(correct)
Grid side
(correct)
Figure 4-328 Primary Charging Wire
Screws
Figure 4-329
(wrong)
(wrong)
4-53