Lens Drive Assembly; Removing The Lens Y Direction Drive Motor - Canon NP6260 Service Manual

B. Lens Drive Assembly
If you turn on the power supply with-
out removing the lens metal fixing of the
lens stage or move the lens or the lens
stage without disconnecting the power
plug, you can damage the gear of the
output shaft.
a. Be sure to remove the lens metal
fixing of the lens stage before con-
necting the power plug when
installing the machine.
b. Be sure to disconnect the power
plug before moving the lens stage or
the zoom lens by hand.
Further, avoid moving without care,
and be sure to hold the area near
the point of engagement with the
rail.
1. Removing the Lens Y Direction
Drive Motor
1) Remove the copyboard glass retain-
er, and remove the copyboard glass.
2) Move the No. 1 mirror mount to the
left.
3) Remove the three mounting screws
, and remove the lens hood
Caution:
When installing the lens hood, fit
the boss of the lens hood in the
cut-off of the rail; then, hook at the
rear while turning the lens hood
clockwise.
COPYRIGHT © 1997 CANON INC.
.
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 EXPOSURE SYSTEM
Figure 3-515
3-31