Fixing/Waste Toner Drive Assembly; Construction; Removing The Waste Toner Bottle; Removing The Fixing/Waste Toner Drive Assembly - Canon NP6260 Service Manual

G. Fixing/Waste Toner Drive
Assembly

1. Construction

2. Removing the Waste Toner Bottle

1) Remove the two mounting screws,
and remove the lower right cover;
then, remove the waste toner bottle
toward the multifeeder.
3. Removing the Fixing/Waste Toner
Drive Assembly
1) Open the front door, and draw out
the process unit, the fixing/feeding
unit, and the holding tray assembly
about 10 cm from the copier.
2) Remove the rear cover.
3) Remove the high-voltage trans-
former PCB.
4) Remove the cleaner fan and the
feeding fan.
5) Remove the waste toner bottle.
6) Remove the spring
the tension pulley
the timing belt
COPYRIGHT © 1997 CANON INC.
, and loosen
; then, detach
.
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
Figure 7-441
Figure 7-442
7-33