Securing The Sd Card With A Password; Setting And Removing An Sd Card Password; Displaying The Sd Card Password Status - Cisco 1120 Hardware Installation

4. To install an SD card in the router:
a. Insert the SD card by sliding it into the SD card slot, with the connector first and the notched corner facing up.
The card is keyed so that you cannot insert it the wrong way.
b. Ensure that the card is seated in the slot connector and the edge of the card is flush with the edge of the slot.
5. Rotate the cover back in place and secure it by tightening the screw to 3.5 in-pounds.
Caution: You must replace the SD card slot cover when not using the card slot. If the card slot is not covered, the router
interior could be exposed to environmental elements that can damage the router.

Securing the SD Card with a Password

Note: The CLI cited in this section work for both the CG-OS and Cisco IOS operating systems.
The SD card contents can be secured with a password. Once a password is set, the password must be supplied before
data can be accessed on the SD card.
The SD card password must be set during system initialization, and you will be notified that the system must be rebooted
for the new password to take effect. The password can be set at the CLI or through the CG-NMS.
To set and remove SD card passwords and display their status, see:

Setting and Removing an SD Card Password, page 83

Displaying the SD Card Password Status, page 83

Setting and Removing an SD Card Password

To set a password for the SD-card, use the sd-card password password command in global configuration mode to set
the password. Use the no sd-card password command in global configuration mode to remove the password.

Displaying the SD Card Password Status

The SD Card password status can be:

Unlocked

Locked

Password set/reset, reboot pending
To determine the status of the SD card password, you can use the show sd-card password status command in user
EXEC mode.
cgr1120# show sd-card password status
SD-card lock status: [Locked, reboot required to apply.]
The command output indicates that the SD card is password secured but the router must be rebooted for the password
to apply.
The status of an SD card fully secured by a password the status is [Locked], and an SD card unsecured by a password
has [Unlocked] status.
83