Debug Condition Standby - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug condition standby

To limit debugging output for standby state changes, use the debug condition standby command. To
disable debugging output, use the no form of this command.
Syntax Description
fastethernet
slot/port
GigabitEthernet
port-channel interface_num
vlan vlan_id
group-number
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
If you attempt to remove the only condition set, you will be prompted with a message asking if you want
to abort the removal operation. You can enter n to abort the removal or y to proceed with the removal. If
you remove the only condition set, an excessive number of debugging messages might occur.
Examples
This example shows how to limit the debugging output to group 0 in VLAN 1:
Switch# debug condition standby vlan 1 0
Condition 3 set
Switch#
This example shows the display if you try to turn off the last standby debug condition:
Switch# no debug condition standby vlan 1 0
This condition is the last standby condition set.
Removing all conditions may cause a flood of debugging
messages to result, unless specific debugging flags
78-16201-01
debug condition standby {fastethernet slot/port | GigabitEthernet slot/port |
port-channel interface-num | vlan vlan_id group-number}
no debug condition standby {fastethernet slot/port | GigabitEthernet slot/port |
port-channel interface-num | vlan vlan_id group-number}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for extended VLAN addresses added.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
Limits debugging to Fast Ethernet interfaces.
Number of the slot and port.
Limits debugging to Gigabit Ethernet interfaces.
Limits debugging output to port-channel interfaces; valid values are
from 1 to 64.
Limits debugging of a condition on a VLAN interface; valid values are
from 1 to 4094.
VLAN group number; valid values are from 0 to 255.
debug condition standby
2-45