Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
show policy-map interface
To display statistics and configurations of input and output policies attached to an interface, use the show
policy-map interface command.
Syntax Description
FastEthernet interface-number
GigabitEthernet interface-number
port-channel number
vlan vlan_id
input
output
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History
Release
12.1(8a)EW
12.1(12c)EW
Examples
This example shows how to display statistics and configurations of all input and output policies attached
to an interface:
Switch# show policy-map interface
FastEthernet6/1
service-policy input:ipp5-policy
service-policy output:ipp5-policy
78-16201-01
show policy-map interface [{FastEthernet interface-number} | {GigabitEthernet
interface-number } | {port-channel number } | {vlan vlan_id}] [input | output]
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
class-map:ipp5 (match-all)
0 packets
match:ip precedence 5
set:
ip precedence 6
class-map:class-default (match-any)
0 packets
match:any
0 packets
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
(Optional) Specifies the Fast Ethernet 802.3 interface.
(Optional) Specifies the Gigabit Ethernet 802.3z interface.
(Optional) Specifies the port channel.
(Optional) Specifies the VLAN ID; valid values are from 1
to 4094.
(Optional) Specifies input policies only.
(Optional) Specifies output policies only.
show policy-map interface
2-359