pagp learn-method
pagp learn-method
To learn the input interface of incoming packets, use the pagp learn-method command. To return to the
default value, use the no form of this command.
Syntax Description
aggregation-port
physical-port
Defaults
Aggregation port is enabled.
Command Modes
Interface configuration
Command History
Release
12.1(8a)EW
Examples
This example shows how to enable port channel address learning:
Switch(config-if)# pagp learn-method
Switch(config-if)#
This example shows how to enable physical port address learning within the bundle:
Switch(config-if)# pagp learn-method physical-port
Switch(config-if)#
This example shows how to enable aggregation port address learning within the bundle:
Switch(config-if)# pagp learn-method aggregation-port
Switch(config-if)#
Related Commands
pagp learn-method
show pagp
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-188
pagp learn-method {aggregation-port | physical-port}
no pagp learn-method
Specifies learning the address on the port channel.
Specifies learning the address on the physical port within the bundle.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01