Cisco 4500M Command Reference Manual page 473

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
•
Examples
This example shows how to enable PortFast mode:
Switch(config-if)# spanning-tree portfast
Switch(config-if)
Related Commands
spanning-tree cost
spanning-tree port-priority
spanning-tree portfast default
spanning-tree uplinkfast
spanning-tree vlan
show spanning-tree
78-16201-01
no spanning-tree portfast —This command implicitly enables PortFast if the
portfast default command is defined in global configuration and if the port is not a trunk port. If
you do not configure PortFast globally, the no spanning-tree portfast command is equivalent to the
spanning-tree portfast disable command.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
spanning-tree portfast (interface configuration mode)
spanning-tree
2-441