debug condition interface
debug condition interface
To limit debugging output of interface-related activities, use the debug condition interface command.
To disable debugging output, use the no form of this command.
Syntax Description
fastethernet
slot/port
GigabitEthernet
null interface-num
port-channel interface-num
vlan vlan_id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History
Release
12.1(8a)EW
12.1(12c)EW
Examples
This example shows how to limit debugging output to VLAN interface 1:
Switch# debug condition interface vlan 1
Condition 2 set
Switch#
Related Commands
debug interface
undebug condition interface (same as no debug condition interface)
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-44
debug condition interface {fastethernet slot/port | GigabitEthernet slot/port |
null interface_num | port-channel interface-num | vlan vlan_id }
no debug condition interface {fastethernet slot/port | GigabitEthernet slot/port | null
interface_num | port-channel interface-num | vlan vlan_id}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for extended VLAN addresses added.
Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Limits debugging to Fast Ethernet interfaces.
Number of the slot and port.
Limits debugging to Gigabit Ethernet interfaces.
Limits debugging to null interfaces; the valid value is 0.
Limits debugging to port-channel interfaces; valid values are from 1
to 64.
Specifies the VLAN interface number; valid values are from 1 to 4094.
78-16201-01