Ip Igmp Snooping Vlan Static - Cisco 4500M Command Reference Manual

ip igmp snooping vlan static

ip igmp snooping vlan static
To configure an Layer 2 interface as a member of a group, use the ip igmp snooping vlan static
command. To remove the configuration, use the no form of this command.
Syntax Description
vlan vlan_num
static mac-address
interface
FastEthernet slot/port
GigabitEthernet slot/port
port-channel number
Defaults
This command has no default settings.
Command Modes
Global configuration
Command History Release
12.1(8a)EW
Examples
This example shows how to configure a host statically on an interface:
Switch(config)# ip igmp snooping vlan 4 static 0100.5e02.0203 interface fastethernet 5/11
Configuring port FastEthernet5/11 on group 0100.5e02.0203 vlan 4
Switch(config)#
Related Commands
ip igmp snooping
ip igmp snooping vlan immediate-leave
ip igmp snooping vlan mrouter
show mac-address-table multicast
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-146
ip igmp snooping vlan vlan_num static mac-address {interface {FastEthernet slot/port} |
{GigabitEthernet slot/port} | {port-channel number }}
no ip igmp snooping vlan vlan_num static {{interface {FastEthernet slot/port} |
{GigabitEthernet slot/port} | {port-channel number }}
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Number of the VLAN.
Group MAC address.
Specifies the next-hop interface to multicast switch.
Specifies the Fast Ethernet interface. Number of the slot and port.
Specifies the Gigabit Ethernet interface. Number of the slot and port.
Port channel number; valid values are from 1 through 64.
78-16201-01