Show Ip Igmp Interface - Cisco 4500M Command Reference Manual

show ip igmp interface

show ip igmp interface
To view IP IGMP interface status and configuration information, use the show ip igmp interface
command.
Syntax Description
FastEthernet
slot/port
GigabitEthernet
slot/port
null
interface-number
vlan vlan_id
Defaults
If you do not specify a VLAN, information for VLAN 1 is shown.
Command Modes
Privileged EXEC
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
If you omit the optional arguments, the show ip igmp interface command displays information about
all interfaces.
Examples
This example shows how to view IGMP information for VLAN 200:
Switch# show ip igmp interface vlan 200
IGMP snooping is globally enabled
IGMP snooping is enabled on this Vlan
IGMP snooping immediate-leave is disabled on this Vlan
IGMP snooping mrouter learn mode is pim-dvmrp on this Vlan
IGMP snooping is running in IGMP-ONLY mode on this VLAN
Switch#
Related Commands
clear ip igmp group
show ip igmp snooping mrouter
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-306
show ip igmp interface [FastEthernet slot/port | GigabitEthernet slot/port |
null interface-number | vlan vlan_id]
(Optional) Specifies the Fast Ethernet interface and the number of the slot and
port.
(Optional) Specifies the Gigabit Ethernet interface and the number of the slot and
port; valid values are from 1 to 9.
(Optional) Specifies the null interface and the number of the interface; the only
valid value is 0.
(Optional) Specifies the VLAN and the number of the VLAN; valid values are
from 1 to4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01