Qos Map Dscp Policed - Cisco 4500M Command Reference Manual

qos map dscp policed

qos map dscp policed
To set the mapping of policed DSCP values to marked-down DSCP values, use the qos map dscp
policed command. To remove a prior entry, use the no form of this command.
Syntax Description
dscp_list
to dscp
policed_dscp
Defaults
Mapping of DSCP values is disabled.
Command Modes
Global configuration
Command History Release
12.1(8a)EW
Usage Guidelines
The DSCP-to-policed-DSCP map determines the marked-down DSCP value applied to out-of-profile
flows. The switch has one map.
You can enter up to eight DSCP values, separated by spaces.
You can enter only one policed DSCP value.
Note
To avoid out-of-sequence packets, configure the DSCP-to-policed-DSCP map so that marked-down
packets remain in the same queue as in-profile traffic.
Examples
This example shows how to map multiple DSCPs to a single policed-DSCP value:
Switch(config)# qos map dscp policed 20 25 43 to dscp 4
Switch(config)#
Related Commands
qos map cos
qos map dscp
show qos
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-222
qos map dscp policed dscp_list to dscp policed_dscp
no qos map dscp policed
DSCP values; valid values are from 0 to 63.
Defines mapping.
Marked-down DSCP values; valid values are from 0 to 63.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01