Cisco 4500M Command Reference Manual page 141

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Valid values for interface-type are as follows:
•
•
•
You cannot specify both a macro and an interface range in the same command. After creating a macro,
you can enter additional ranges. Likewise, if you have already entered an interface range, the CLI does
not allow you to enter a macro.
You can specify a single interface in the port-range value. This makes the command similar to the
interface interface-number command.
Examples
This example shows how to use the interface range command to interface to FE 5/18 - 20:
Switch(config)# interface range fastethernet 5/18 - 20
Switch(config-if)#
This command shows how to run a port-range macro:
Switch(config)# interface range macro macro1
Switch(config-if)#
Related Commands
define interface-range
show running config (refer to Cisco IOS documentation)
78-16201-01
FastEthernet
GigabitEthernet
Vlan vlan_id
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
interface range
2-109