How To Find Command Options - Cisco 4500M Command Reference Manual

Chapter1 Command-Line Interface
Table1-2 How to Find Command Options (continued)
Command
Switch(config-if)# ?
Interface configuration commands:
access-expression Build a bridge boolean access expression
apollo Apollo interface subcommands
appletalk Appletalk interface subcommands
arp Set arp type (arpa, probe, snap) or timeout
backup Modify backup parameters
bandwidth Set bandwidth informational parameter
bgp-policy Apply policy propogated by bgp community string
bridge-group Transparent bridging interface parameters
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
channel-group Etherchannel/port bundling configuration
clns CLNS interface subcommands
cmns OSI CMNS
custom-queue-list Assign a custom queue list to an interface
decnet Interface DECnet config commands
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dlsw DLSw interface subcommands
dspu Down Stream PU
exit Exit from interface configuration mode
fair-queue Enable Fair Queuing on an Interface
flowcontrol Configure flow operation.
fras DLC Switch Interface Command
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
ipx Novell/IPX interface subcommands
isis IS-IS commands
iso-igrp ISO-IGRP interface subcommands
.
.
.
Switch(config-if)#
Switch(config-if)# channel-group ?
group channel-group of the interface
Switch(config-if)#channel-group
78-16201-01
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW

How to Find Command Options

Purpose
Enter a ? to display a list of all the
interface configuration commands
available for the Gigabit Ethernet
interface.
Enter the command that you want to
configure for the controller. In this
example, the channel-group
command is used.
Enter a ? to display what you must
enter next on the command line. In
this example, you must enter the
group keyword.
Because a is not displayed, it
<cr>
indicates that you must enter more
information to complete the
command.
1-3