Ip Igmp Filter - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

ip igmp filter

To control whether all hosts on a Layer2 interface can join one or more IP multicast groups by applying
an IGMP profile to the interface, use the ip igmp filter command. To remove a profile from the interface,
use the no form of this command
Syntax Description
profile number
Defaults
Profiles are not applied.
Command Modes
Interface configuration
Command History Release
12.1(11b)EW
Usage Guidelines
You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples
This example shows how to apply IGMP profile 22 to an interface.
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# ip igmp filter 22
Switch(config-if)#
Related Commands
ip igmp profile
show ip igmp profile
78-16201-01
ip igmp filter profile number
no ip igmp filter
IGMP profile number to be applied; valid values are from 1 to 429496795.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
ip igmp filter
2-133