Cisco 4500M Command Reference Manual page 492

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
switchport access vlan
Note
This command is not used on platforms that do not support Cisco-routed ports. All physical ports on such
platforms are assumed to be Layer 2-switched interfaces.
This example shows how to cause a port interface that has already been configured as a switched
interface to operate in VLAN 2 instead of the platform's default VLAN when in access mode:
Switch(config-if)# switchport access vlan 2
Switch(config-if)#
Related Commands
show interfaces switchport
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-460
78-16201-01