Show Pagp - Cisco 4500M Command Reference Manual

show pagp

show pagp
To display port channel information, use the show pagp command.
Syntax Description
group-number
counters
internal
neighbor
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(8a)EW
Usage Guidelines
You can enter any show pagp command to display the active PAgP port channel information. To display
the nonactive information, enter the show pagp command with a group.
Examples
This example shows how to display PAgP counter information:
Switch# show pagp counters
Port
--------------------------------------
Channel group: 1
Fa5/4
Fa5/5
Channel group: 2
Fa5/6
Fa5/7
Switch#
This example shows how to display internal PAgP information:
Switch# show pagp 1 internal
Flags:
Timers: H - Hello timer is running.
Channel group 1
Port
Fa5/4
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-356
show pagp [group-number ] {counters | internal | neighbor}
(Optional) Channel group number; valid values are from 1 to 64.
Specifies traffic counter information.
Specifies PAgP internal information.
Specifies PAgP neighbor information.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Information
Sent Recv
2660 2452
2676 2453
289 261
290 261
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Flags State Timers
SC U6/S7
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Flush
Sent Recv
0 0
0 0
0 0
0 0
C - Device is in Consistent state.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner
Interval Count Priority
30s 1
PAgP Learning
Method IfIndx
128 Any 129
78-16201-01