Disabling Host Route Reception; Advertising A Default Route - HP 830 Series Configuration Manual

Step
6. Configure a summary route.

Disabling host route reception

Perform this task to disable RIPv2 from receiving host routes from the same network and save network
resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Step
1. Enter system view.
2. Enter RIP view.
3. Disable RIP from receiving
host routes.

Advertising a default route

You can advertise a default route on all RIP interfaces in RIP view or a specific RIP interface in interface
view. The interface view setting takes precedence over the RIP view settings.
To disable an interface from advertising a default route, use the rip default-route no-originate command
on the interface.
To configure RIP to advertise a default route:
Step
1. Enter system view.
2. Enter RIP view.
3. Enable RIP to advertise a
default route.
4. Return to system view.
5. Enter interface view.
6. Configure the RIP interface to
advertise a default route.
NOTE:
The router enabled to advertise a default route does not receive default routes from RIP neighbors.
Command
rip summary-address ip-address
{ mask | mask-length }
Command
system-view
rip [ process-id ]
undo host-route
Command
system-view
rip [ process-id ]
default-route { only | originate }
[ cost cost ]
quit
interface interface-type
interface-number
rip default-route { { only |
originate } [ cost cost ] |
no-originate }
137
Remarks
N/A
Remarks
N/A
N/A
By default, RIP receives host routes.
Remarks
N/A
N/A
Optional.
Not enabled by default.
N/A
N/A
Optional.
By default, a RIP interface can
advertise a default route if the RIP
process is configured with default
route advertisement.