Installing The Sd Card Reader Support Bracket; Internal Hard-Drives; Removing A Hard-Drive Carrier - Dell PowerEdge C8000 Hardware Owner's Manual

Installing the SD Card Reader Support Bracket

1 Align the SD card reader support bracket with the screw holes on the sled
tray. See Figure 3-26.
2 Replace the two screws securing the SD card reader support bracket. See
Figure 3-26.
3 Replace the SD card reader. See "Installing the SD Card Reader" on
page 160.
4 Replace the mezzanine card. See "Installing the Infiniband Mezzanine
Card" on page 154 or "Installing the 10 GbE Mezzanine Card" on
page 157.
5 Replace the front cover. See "Installing the Front Cover" on page 133.
6 Replace the sled. See "Installing a Sled" on page 130.

Internal Hard-Drives

The sled supports up to two 2.5-inch hard-drives attached internally to the
sled tray.

Removing a Hard-Drive Carrier

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
is not supported.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 129.
2 Remove the back cover. See "Removing the Back Cover" on page 134.
3 Loosen the thumbscrew securing the hard-drive carrier to the hard-drive
bracket. See Figure 3-27.
4 Slide and lift the hard-drive carrier out of the sled tray. See Figure 3-27.
162
Installing System Components
Many repairs may only be done by a certified service technician. You
Combining SATA and SAS hard-drives in the same sled configuration