Table of Contents
Advertisement
Next steps
1. Install the following:
a.
Drive backplane
b.
Drives
2. Follow the procedure listed in
3. Enter the System Setup to confirm that the battery is operating properly.
4. Enter the correct time and date in the System Setup's Time and Date fields.
5. Exit the System Setup.
6. To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7. Reinstall the system into the enclosure, after an hour.
8. Enter the System Setup and if the time and date are still incorrect, see the Getting help section.
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replacing optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the USB port or USB memory key on the system board.
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional MicroSD or vFlash card
Removing the internal micro SD card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
Locate the micro SD card slot on the internal dual SD module (IDSDM), and press the card to release it from the slot.
NOTE:
Temporarily label each micro SD card with its corresponding slot number before removal. Reinstall the micro SD
cards into the corresponding slots.
After working inside your system
Safety instructions
on page 46.
Before working inside your system
After working inside your system
Safety instructions
on page 46.
Before working inside your system
on page 47.
System board jumpers and connectors
on page 46.
on page 47.
on page 46.
Installing and removing system components
section.
89
Advertisement
Table of Contents
