Installing The Idsdm Module; Microsd Card; Removing The Micro-Sd Card - Dell VCG3C Assembly, Installation And Service Manual

Installing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Locate the IDSDM connector on the system board.
To locate IDSDM, see the
2. Align and insert the IDSDM module into the connector on the system board, until it is firmly seated.
3. Push IDSDM module until it is firmly seated in the connector on the system board.
Figure 58. Installing the IDSDM module
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Install the air shroud.
3. Follow the procedure listed in the

MicroSD card

Removing the Micro-SD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
62 Installing and removing system components
Safety instructions.
Before working inside your
System board jumpers and connectors section.
After working inside the
Safety instructions.
Before working inside your
system.
system.
system.