Sd Card Reader; Removing The Sd Card Reader - Dell PowerEdge C8000 Hardware Owner's Manual

4 Replace the screw securing the mezzanine card bridge board to the
bracket. See Figure 3-22.
5 Lower the 10 GbE mezzanine card assembly to the sled tray. See
Figure 3-21.
6 Replace the two screws securing the 10 GbE mezzanine card assembly to
the sled tray. See Figure 3-21.
7 Replace the front cover. See "Installing the Front Cover" on page 133.
8 Replace the sled. See "Installing a Sled" on page 130.

SD Card Reader

Removing the SD Card Reader

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 129.
2 Remove the front cover. See "Removing the Front Cover" on page 132.
3 Remove the mezzanine card. See "Removing the Infiniband Mezzanine
Card" on page 151 or "Removing the 10 GbE Mezzanine Card" on
page 155.
4 If installed, remove the SD card. Locate the SD card slot in the SD card
reader and press inward on the card to release it from the slot and remove
the card. See Figure 3-24.
158
Installing System Components
Many repairs may only be done by a certified service technician. You