Removing The Expansion Card Riser Assembly - Dell EMC PowerEdge C6420 Manual

Location Card type
Slot 4 SolarFlare Flareon
SFN8522 10GE SFP
Dual Port Adapter
Slot 4 Intel 10GbE Quad
Port X710-t Adapter
Slot 4 Intel Gigabit Dual
Port I350-t Adapter,
1GB
Slot 4 Broadcom 5720 DP
1G Adapter,
1000Mbps

Removing the expansion card riser assembly

Prerequisites
NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sled from the enclosure.
Steps
1 Remove the screws that secure the expansion card riser assembly.
2 Lift the expansion card riser assembly out of the sled.
Figure 41. Removing the expansion card riser assembly
Next step
Install the expansion card riser assembly.
Form factor
Low profile
Low profile
Low profile
Low profile
Safety instructions.
Before working inside your
Link width
x8
x8
x4
x1
system.
Installing and removing system components
Slot priority Maximum number of
cards
4 1
4 1
4 1
4 1
95