Removing The Expansion Card Riser Assembly - Dell PowerEdge C6320p Owner's Manual

Location
Mezzanine slot

Removing the expansion card riser assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system
and aid in proper cooling and airflow inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Keep the Phillips #2 screwdriver ready.
Steps
1. Remove the screws that secure the expansion card riser assembly.
2. Lift the expansion card riser assembly out of the sled.
100
Card type
Mellanox ConnectX-4
Dual Port 100 GbE
QSFP Adapter
Mellanox ConnectX-4
Single Port VPI EDR
QSFP+ Adapter
Mellanox ConnectX-4
Dual Port VPI EDR
QSFP+ Adapter
QSFP carrier card (with
fabric processor only)
LSI 2008 8-Port Adapter Mezzanine card
Intel Gigabit Dual Port
I350-t Adapter
Intel 82599 Dual Port
10G Adapter
Form factor
Low Profile
Low Profile
Low Profile
Low Profile
Mezzanine card
Mezzanine card
Link width
x8
x8
x8
N/A
x8
x8
x8
Slot width
x16
x16
x16
N/A
x4
x4
x4