Network Filter Configuration; Route Map Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Network Filter configuration

The following table describes the Network Filter Configuration commands.
Table 125 Network Filter Configuration commands
Command
ip match-address <1-256> <IP address>
<IP netmask>
ip match-address <1-256> enable
no ip match-address <1-256> enable
no ip match-address <1-256>
show ip match-address [<1-256>]

Route Map configuration

Routing maps control and modify routing information. The map number <1-32> represents the routing
map you wish to configure.
The following table describes the basic Route Map Configuration commands. The following sections
provide more detailed information and commands.
Table 126 Route Map Configuration commands
Command
route-map <1-32>
[no] access-list <1-8>
[no] metric <0-16777214>
[no] metric-type {type1|type2}
Description
Sets the starting IP address the IP subnet mask for this filter.
The default address is 0.0.0.0.
This command defines the range of IP addresses that will be
accepted by the peer when the filter is enabled.
Command mode: Global configuration
Enables the Network Filter configuration.
Command mode: Global configuration
Disables the Network Filter configuration.
Command mode: Global configuration
Deletes the Network Filter configuration.
Command mode: Global configuration
Displays the current the Network Filter configuration.
Command mode: All except User EXEC
Description
Enter Route Map configuration mode.
Command mode: Global configuration
Configures the Access List.
Command mode: Route Map
Sets the metric of the matched route.
Command mode: Route Map
Assigns the type of OSPF metric. The default is type 1.
Type 1—External routes are calculated using both internal and
external metrics.
Type 2—External routes are calculated using only the external
metrics. Type 2 routes have more cost than Type 2.
none—Removes the OSPF metric.
Command mode: Route Map
Configuration Commands
140