Ospf Virtual Link Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 134 OSPF Interface Configuration commands
Command
no ip ospf enable
no ip ospf
show interface ip ospf
{<1-255>}

OSPF Virtual Link configuration

The following table describes the OSPF Virtual Link Configuration commands.
OSPF Virtual Link Configuration commands
Table 135
Command
area-virtual-link <1-3> area
<0-2>
area-virtual-link <1-3>
hello-interval <1-65535>
area-virtual-link <1-3>
dead-interval <1-65535>
area-virtual-link <1-3>
transit-delay <1-3600>
area-virtual-link <1-3>
retransmit-interval <1-3600>
area-virtual-link <1-3>
neighbor-router <IP address>
[no] area-virtual-link <1-3>
key <key string>
area-virtual-link <1-3>
message-digest-key <1-255>
area-virtual-link <1-3>
enable
no area-virtual-link <1-3>
enable
no area-virtual-link <1-3>
Description
Disables the OSPF interface.
Command mode: Interface IP
Deletes the OSPF interface.
Command mode: Interface IP
Displays the current settings for OSPF interface.
Command mode: All except User EXEC
Description
Configures the OSPF area index.
Command mode: Router OSPF
Configures the authentication parameters of a hello packet, which is set to
be in an interval of seconds.
Command mode: Router OSPF
Configures the health parameters of a hello packet, which is set to be in an
interval of seconds. Default is 40 seconds.
Command mode: Router OSPF
Configures the delay in transit in seconds. Default is one second.
Command mode: Router OSPF
Configures the retransmit interval in seconds. Default is five seconds.
Command mode: Router OSPF
Configures the router ID of the virtual neighbor. Default is 0.0.0.0.
Command mode: Router OSPF
Configures the password (up to eight characters) for each virtual link.
Default is none.
Command mode: Router OSPF
Sets MD5 key ID for each virtual link. Default is none.
Command mode: Router OSPF
Enables OSPF virtual link.
Command mode: Router OSPF
Disables OSPF virtual link.
Command mode: Router OSPF
Deletes OSPF virtual link.
Command mode: Router OSPF
Configuration Commands
148