Temporarily Disabling A Port; Port Link Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 97 Port Configuration commands
Command
dest-lookup-threshold
{<0-262143>}
no shutdown
shutdown
show interface port {<port
number>}

Temporarily disabling a port

To temporarily disable a port without changing its stored configuration attributes, enter the following
command at any prompt:
Switch# interface port <port number> shutdown
Because this configuration sets a temporary state for the port, you do not need to perform a save
operation. The port state reverts to its original configuration when the switch is reloaded.

Port link configuration

Use these commands to set port parameters for the port link.
Link commands are described in the following table. Using these commands, you can set port parameters
such as speed, duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration commands.
Table 98 Gigabit Link Configuration commands
Command
speed
{100|1000|10000|auto}
Description
Limits the number of unknown unicast packets per second to the specified
value. If disabled (dis), the port forwards all unknown unicast packets.
Command mode: Interface port
Enables the port.
Command mode: Interface port
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the "Temporarily disabling a port" section later
in this chapter.
Command mode: Interface port
Displays current port parameters.
Command mode: All
Description
Sets the link speed. Not all options are valid on all ports. The choices include:
10 Mbps
100 Mbps
1000 Mbps
auto for automatic detection (default)
Ports 19-21 are set to 10000 Mbps, and cannot be changed.
NOTE:
Command mode: Interface port
Configuration Commands
119