Ip Forwarding Configuration; Network Filter Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

IP Forwarding configuration

The following table describes the IP Forwarding Configuration commands.
IP Forwarding Configuration commands
Table 124
Command
[no] ip routing direct-broadcasts
ip routing
no ip routing
show ip routing

Network Filter configuration

The following table describes the Network Filter Configuration commands.
Network Filter Configuration commands
Table 125
Command
ip match-address <1-256> <IP address>
<IP netmask>
ip match-address <1-256> enable
no ip match-address <1-256> enable
no ip match-address <1-256>
show ip match-address [<1-256>]
Description
Enables or disables forwarding directed broadcasts. This
command is disabled by default.
Command mode: Global configuration
Enables IP forwarding (routing) on the switch.
Command mode: Global configuration
Disables IP forwarding (routing) on the switch. Forwarding is
turned off by default.
Command mode: Global configuration
Displays the current IP forwarding settings.
Command mode: All except User EXEC
Description
Sets the starting IP address the IP subnet mask for this filter.
The default address is 0.0.0.0.
This command defines the range of IP addresses that will be
accepted by the peer when the filter is enabled.
Command mode: Global configuration
Enables the Network Filter configuration.
Command mode: Global configuration
Disables the Network Filter configuration.
Command mode: Global configuration
Deletes the Network Filter configuration.
Command mode: Global configuration
Displays the current the Network Filter configuration.
Command mode: All except User EXEC
Configuration Commands
146