Table 25
Common Internal Spanning Tree parameter descriptions
Parameter
Type
Trunk group information
The following command displays Trunk Group information:
show portchannel information
Command mode: All
Trunk group 1, Enabled
port state:
24: STG
25: STG
When trunk groups are configured, you can view the state of each port in the various trunk groups.
NOTE:
If Spanning Tree Protocol on any port in the trunk group is set to forwarding, the remaining
ports in the trunk group are set to forwarding.
VLAN information
The following table describes the VLAN information commands.
VLAN information commands
Table 26
Command
show vlan
show vlan information
Description
Type of link connected to the port, and whether the port is an edge port. Link type
values are AUTO, P2P, or SHARED.
1 forwarding
1 forwarding
Usage
Displays VLAN information
Command mode: All
Displays VLAN information, including spanning tree assignment.
Command mode: All
Information Commands
42