Spanning Tree Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 107 CIST Port Configuration commands
Command
[no] spanning-tree mst cist
edge
spanning-tree mst cist enable
no spanning-tree mst cist
enable
show interface port {<port
number>} spanning-tree mstp
cist

Spanning Tree configuration

The switch supports the IEEE 802.1d Spanning Tree Protocol (STP) and Cisco proprietary PVST and PVST+
protocols. You can configure up to 127 spanning tree groups on the switch (STG 128 is reserved for
switch management). Spanning Tree is turned on by default.
NOTE: When RSTP is turned on, only STP group 1 can be configured.
The following table describes the Spanning Tree Configuration commands.
Table 108 Spanning Tree Configuration commands
Command
spanning-tree stp {<1-128>} vlan
{<1-4095>}
no spanning-tree stp {<1-128>}
vlan {<1-4095>}
no spanning-tree stp {<1-128>}
vlan all
spanning-tree stp {<1-128>}
enable
no spanning-tree stp {<1-128>}
enable
default spanning-tree <1-128>
show spanning-tree stp {<1-128>}
Description
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as
the link is up. Configure server ports as edge ports (enabled). This
command is disabled by default.
Command mode: Interface port
Enables CIST on the port.
Command mode: Interface port
Disables CIST on the port.
Command mode: Interface port
Displays the current CIST port configuration.
Command mode: All
Description
Associates a VLAN with a spanning tree and requires an external
VLAN ID as a parameter.
Command mode: Global configuration
Breaks the association between a VLAN and a spanning tree and
requires an external VLAN ID as a parameter.
Command mode: Global configuration
Removes all VLANs from a spanning tree.
Command mode: Global configuration
Globally enables Spanning Tree Protocol.
Command mode: Global configuration
Globally disables Spanning Tree Protocol.
Command mode: Global configuration
Restores a spanning tree instance to its default configuration.
Command mode: Global configuration
Displays current Spanning Tree Protocol parameters.
Command mode: All
Configuration Commands
128