The following table describes the VRRP Interface Configuration commands.
VRRP Interface Configuration commands
Table 152
Command
interface <1-256>
authentication
{password|none}
interface <1-256>
password <password>
no interface <1-256>
show ip vrrp interface
<1-256>
VRRP Tracking configuration
These commands are used for setting weights for the various criteria used to modify priority levels during
the master router election process. Each time one of the tracking criteria is met, the priority level for the
virtual router is increased.
The following table describes the VRRP Tracking Configuration commands.
VRRP Tracking Configuration commands
Table 153
Command
tracking-priority-increment
virtual-routers <0-254>
tracking-priority-increment
interfaces <0-254>
tracking-priority-increment
ports <0-254>
show ip vrrp tracking-
priority-increment
NOTE:
These priority tracking options only define increment values. These options do not affect the
VRRP master router election process until options under VRRP Virtual Router Priority Tracking are
enabled.
Description
Defines the type of authentication that will be used: none (no authentication), or
password (password authentication).
Command mode: Router VRRP
Defines a plain text password up to eight characters long. This password will be
added to each VRRP packet transmitted by this interface when password
authentication is chosen.
Command mode: Router VRRP
Clears the authentication configuration parameters for this IP interface. The IP
interface itself is not deleted.
Command mode: Router VRRP
Displays the current configuration for this IP interface's authentication parameters.
Command mode: All except User EXEC
Description
Defines the priority increment value (0 through 254) for virtual routers in
master mode detected on this switch. The default value is 2.
Command mode: Router VRRP
Defines the priority increment value (0 through 254) for active IP
interfaces detected on this switch. The default value is 2.
Command mode: Router VRRP
Defines the priority increment value (0 through 254) for active ports on the
virtual router's VLAN. The default value is 2.
Command mode: Router VRRP
Displays the current configuration of priority tracking increment values.
Command mode: All except User EXEC
Configuration Commands
161