Vrrp Virtual Router Group Priority Tracking Configuration; Vrrp Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 150 Virtual Router Group Configuration commands
Command
group enable
no group enable
no group
show ip vrrp group

VRRP Virtual Router Group Priority Tracking configuration

The following table describes the Virtual Router Group Priority Tracking Configuration commands.
Table 151 Virtual Router Group Priority Tracking Configuration commands
Command
[no] group track interfaces
[no] group track ports
show ip vrrp group track
NOTE:
If Virtual Router Group Tracking is enabled, the tracking option is available only under the
group option. The tracking setting for the other individual virtual routers is ignored.

VRRP Interface configuration

These commands are used for configuring VRRP authentication parameters for the IP interfaces used with
the virtual routers. The interface number <1-256> represents the IP interface on which authentication
parameters must be configured.
Description
Enables the virtual router group.
Command mode: Router VRRP
Disables the virtual router group.
Command mode: Router VRRP
Deletes the virtual router group from the switch configuration.
Command mode: Router VRRP
Displays the current configuration information for the virtual router group.
Command mode: All except User EXEC
Description
When enabled, the priority for this virtual router will be increased for each
other IP interface active on this switch. An IP interface is considered active
when there is at least one active port on the same VLAN. This helps elect the
virtual routers with the most available routes as the master. This command is
disabled by default.
Command mode: Router VRRP
When enabled, the priority for this virtual router will be increased for each
active port on the same VLAN. A port is considered "active" if it has a link
and is forwarding traffic. This helps elect the virtual routers with the most
available ports as the master. This command is disabled by default.
Command mode: Router VRRP
Displays the current configuration for priority tracking for this virtual router.
Command mode: All except User EXEC
Configuration Commands
160